...
| Table of Contents |
|---|
Networking Requirments
Figure 1. IGMP Snooping Networking
As shown in Figure 1, Host A, Host B, and Host C connect to a multicast source through a Layer 2 Switch and a Layer 3 Router to receive multicast data from the Source device.
...
- To prevent aging of dynamic routing interfaces, configure Ge-1/1/3 as a static router port.
Procedure
Step1 Configure VLAN.
...
| Code Block |
|---|
admin@Xorplus# set protocols igmp-snooping vlan-id 2 enable true |
NOTE: After the global IGMP snooping is enabled, IGMP snooping in the VLAN is disabled by default. To enable IGMP snooping in a VLAN, you also need to enable the VLAN-based IGMP snooping function. After IGMP Snooping is enabled in a VLAN, it will take effect only on interfaces that have already been added to this VLAN. |
Step4 (Optional) Configure the number of times that the querier sends a group-specific query message.
...
| Code Block |
|---|
admin@Xorplus# set protocols igmp-snooping vlan-id 2 static group 238.255.0.1 interface ge-1/1/1 |
Verify the Configuration
- You can use the run show igmp-snooping command to view the configuration information of IGMP snooping.
...