...
Figure 1. BGP Load Balancing
Procedure
This section describes the steps of how to configure basic BGP functions on SwitchA, SwitchB, SwitchC and SwitchD.
Switch A
Step1 Configure the VLANs and VLAN interfaces.
...
| Code Block |
|---|
admin@SwitchA# set protocols bgp router-id 1.1.1.1
admin@SwitchA# set protocols bgp local-as 100
admin@SwitchA# set protocols bgp neighbor 192.168.30.2 remote-as 200
admin@SwitchA# set protocols bgp neighbor 192.168.40.2 remote-as 300
admin@SwitchA# set protocols bgp ebgp-requires-policy false |
Step3 Enable IP routing.
...
| Code Block |
|---|
admin@SwitchB# set protocols bgp router-id 2.2.2.2
admin@SwitchB# set protocols bgp local-as 200
admin@SwitchB# set protocols bgp neighbor 192.168.30.1 remote-as 100
admin@SwitchB# set protocols bgp neighbor 192.168.20.1 remote-as 400
admin@SwitchB# set protocols bgp ebgp-requires-policy false |
Step3 Enable IP routing.
...
| Code Block |
|---|
admin@SwitchC# set protocols bgp router-id 3.3.3.3
admin@SwitchC# set protocols bgp local-as 300
admin@SwitchC# set protocols bgp neighbor 192.168.40.1 remote-as 100
admin@SwitchC# set protocols bgp neighbor 192.168.50.1 remote-as 400
admin@SwitchB# set protocols bgp ebgp-requires-policy false |
Step3 Enable IP routing.
...
| Code Block |
|---|
admin@SwitchD# set protocols bgp router-id 4.4.4.4
admin@SwitchD# set protocols bgp local-as 400
admin@SwitchD# set protocols bgp neighbor 192.168.20.2 remote-as 200
admin@SwitchD# set protocols bgp neighbor 192.168.50.2 remote-as 300
admin@SwitchD# set protocols bgp ebgp-requires-policy false |
Step3 Enable IP routing.
...