...
The run show pim neighbors neighbor command shows information about PIM neighbors.
...
Command Syntax
run show pim neighbors
Parameter
None.neighbor
Example
- Show information about PIM neighbors.
| Code Block |
|---|
admin@Xorplus# run show pim neighbors Interface DRpriority NeighborAddr V Mode Holdtime Timeout neighbor Interface Neighbor Uptime Holdtime DR Pri ---------- ---------- ------------- - ---- ----- --- ------- vlan20 1 vlan20 20.0.0.2 2 Sparse 105 84 vlan60 1 60.0.0.3 2 Sparse 105 83 |
Table 1 Description of the run show pim neighbors command output
...
Item
...
Description
...
Interface
...
Indicates interfaces that enabled PIM-SM.
...
DRpriority
...
Indicates DR priority.
...
NeighborAddr
...
Indicates the neighbor address.
...
V
...
Indicates the version of PIM protocol. Currently the only PIM version 2 is supported.
...
Mode
...
Indicates that mode of the PIM protocol, Sparse or Dense. Currently the only Sparse mode is supported.
...
Holdtime
...
Holdtime of the PIM neighbor.
...
Timeout
...
2 105 84 1 |