Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Info
titleNOTE:

Syslog protocol runs in management VRF by default. If you use Ethernet management interface Eth0/1 to connect with the syslog server, you do not need to do the following operations.

However, if the L3 VLAN interface is used to connect with the syslog server, the syslog protocol cannot run normally by default, as all the L3 VLAN interface is in the default VRF by default. You need to modify the configurations to make the L3 VLAN interface management interface and syslog protocol run in the same VRF, so as to run the syslog protocol normally. You can choose either one of the following two ways:

Way 1. Use the command set system management-services vrf default to move syslog protocol to run in the default VRF. This way is recommended. Note that using this command also moves the NTP/TACACS+/RADIUS management services to the default VRF.

Way 2. Use the command set set l3-interface vlan-interface interface <interface-name> vrf mgmt-vrf to move the L3 VLAN interface connected to the syslog Collector to management VRF.

...