...
| Info | ||
|---|---|---|
| ||
Enable IP routing function before using this feature, for details please refer to Configuring IP Routing. |
In L2/L3, all routing entries will be configured to the ASIC switching chip if the outgoing VLAN-interface is link-up, and the outgoing physical port is learning.
...
| Code Block |
|---|
admin@XorPlus# set vlans vlan-id 2 admin@XorPlus# set vlans vlan-id 3 admin@XorPlus# set interface gigabit-ethernet ge-1/1/1 family ethernet-switching native-vlan-id 2 admin@XorPlus# set interface gigabit-ethernet ge-1/1/2 family ethernet-switching native-vlan-id 3 admin@XorPlus# set vlans vlan-id 2 l3-interface vlan-2 admin@XorPlus# set vlans vlan-id 3 l3-interface vlan-3 admin@XorPlus# commit Waiting for merging configuration. Commit OK. Save done. admin@XorPlus# set vlan-interface interface vlan-2 vifset l3-interface vlan-interface vlan-2 address 192.168.1.1 prefix-length 24 admin@XorPlus# set vlanset l3-interface vlan-interface interface vlan-3 vif vlan-2 address 192.168.2.1 prefix-length 24 admin@XorPlus# set protocols static route 10.10.1.0/24 next-hop 192.168.2.5 admin@XorPlus# commit Waiting for merging configuration. Commit OK. Save done. admin@XorPlus# run show route table ipv4 unicast final 10.10.1.0/24 [static(1)/1] > to 192.168.2.5 viavlan-3/vlan-3 192.168.1.0/24 [connected(0)/0] > via vlan-2/vlan-2 192.168.2.0/24 [connected(0)/0] > via vlan-3/vlan-3 admin@XorPlus# admin@XorPlus# run show route forward-route ipv4 all Destination NetMask NextHopMac Port --------------- --------------- ----------------- --------- 10.10.1.0 255.255.255.0 00:1E:68:37:EF:7D ge-1/1/2 192.168.1.0 255.255.255.0 C8:0A:A9:04:49:28 connected 192.168.2.0 255.255.255.0 C8:0A:A9:04:49:28 connected |
With the show route forward-routeipv4 all command, all the route entries in the ASIC chip will be displayed. Following the show route table ipv4 unicastfinal command, all routes in the RIB of the kernel will be displayed.
Configure max-route-limit.
...
Note: The switch supports 12k ipv4 routes at most and 6k ipv6 routes at most. One ipv6 route is equal to two ipv4 routes. The directly-connected routes are not excepted to route limit.