Page Comparison

Before you deploy switches, configure each switch model that you want to manage with AmpCon-DCCampusampus. If not, the default port number ranges and built-in PicOS images are used to deploy switches with these switch models.

...

Click Service > Switch Model in the AmpCon-DC Campusampus UI, and then check whether the PicOS image to install is listed in the Deployed ONIE Image drop-down list.

• If the image is not listed there, upload the PicOS image and its MD5 file to AmpCon-DCCampusampus. For more information, see Uploading Images.

• If the image is listed there, you don’t need to upload the PicOS image and its MD5 file.

...

To configure a switch model, follow these steps:

1. In the AmpCon-DC Campusampus UI, click Service > Switch Model.

2. Optional: Refresh the supported switch model list:

   1. Click Update Switch Model.

   2. Click Yes to confirm the update.

...

Note: If the PicOS image to install is not listed here, upload the PicOS image and its MD5 file to AmpCon-DCCampusampus. For more information, see Uploading Images.

...

Note: After you reset a switch model, the port number range for each speed is set to zero, and the PicOS image in the Deployed ONIE Image drop-down list is reset to the built-in image.

1. In the AmpCon-DC Campusampus UI, click Service > Switch Model.

2. Click Reset.

3. Click Save.

...