Before you deploy switches, configure each switch model that you want to manage with AmpCon-DC. If not, the default port number ranges and built-in PicOS images are used to deploy switches with these switch models.
| Table of Contents | ||
|---|---|---|
|
Prerequisite
Click Service > Switch Model in the AmpCon-DC UI, and then check whether the PicOS image to install is listed in the Deployed ONIE Image drop-down list.
If the image is not listed there, upload the PicOS image and its MD5 file to AmpCon-DC. For more information, see Uploading Images.
If the image is listed there, you don’t need to upload the PicOS image and its MD5 file.
Configuring a Switch Model
To configure a switch model, follow these steps:
In the AmpCon-DC UI, click Service > Switch Model.
Optional: Refresh the supported switch model list:
Click Update Switch Model.
Click Yes to confirm the update.
In the Switch Model drop-down list, select the switch model that you want to configure.
Configure the port number range for each speed.
In the Deployed ONIE Image drop-down list, select the PicOS image that you want to install for this switch model.
Note: If the PicOS image to install is not listed here, upload the PicOS image and its MD5 file to AmpCon-DC. For more information, see Uploading Images.
Click Save.
Optional: Resetting a Switch Model
To reset a switch model, follow these steps:
Note: After you reset a switch model, the port number range for each speed is set to zero, and the PicOS image in the Deployed ONIE Image drop-down list is reset to the built-in image.
In the AmpCon-DC UI, click Service > Switch Model.
Click Reset.
Click Save.