Page Comparison

The set ipipv6-source-guard verify command configures IP IPv6 source guard filtering item based on specific interface and VLAN.

The delete ipipv6-source-guard verify command deletes the configuration.

Command Syntax

set ipipv6-source-guard interface <interface-name> vlan <vlan-id> verify <ip | ip+mac>

delete ipipv6-source-guard interface <interface-name> vlan <vlan-id> verify

...

Parameter	Description
interface <interface-name>	Specifies an ingress interface name. The value is a physical port or a LAG port, such as ge-1/1/1, te-1/1/2, ae1. Note: IP IPv6 source guard be enabled on a physical interface or a Link Aggregation Group (LAG) interface but cannot be enabled on the member interfaces of a LAG.
vlan <vlan-id>	Specifies a VLAN ID. The value is an integer that ranges from 1 to 4094. For IP IPv6 source guard static binding table, specifies the VLAN ID manually configured in IP IPv6 source guard static binding table. For IP IPv6 source guard dynamic binding table, specifies the VLAN ID enabled DHCP DHCPv6 snooping.
verify <ip \| ip+mac>	Specifies the filtering item based on specific interface and VLAN. The value could be ip or ip+mac. When “ip” is specified, enables IP IPv6 Source Guard with interface + VLAN + Source IP filtering. When “ip+mac” is specified, enables IP IPv6 Source Guard with interface + VLAN + Source IP + Source MAC address filtering. The default value is ip, IP IPv6 Source Guard filtering item is interface + VLAN + Source IP.

Example

Configure IP IPv6 source guard filtering item based on specific interface and VLAN.

Code Block
admin@PICOS# set ipipv6-source-guard interface te-1/1/3 vlan 20 verify ip+mac admin@PICOS# commit

Versions Compared