...
Parameter | Description |
vrf <vrf-name> | Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>]. |
| neighbor <ip> | Specifies the IPv4/IPv6 address of a peer. |
| peer-group <peer-group> | Specifies a peer group. |
| interface <interface> | Specifies an L3 interface for BGP connection. The value could be a VLAN interface name, loopback interface name, routed interface or sub-interface name. |
| <hold time> | Specifies the hold time. Default: 9 180 seconds. Range: 0-65535. |
Usage Guidelines
By default, BGP exchanges periodic keepalive messages to measure and ensure that a peer is still alive and functioning. If a keepalive or update message is not received from the peer within the hold time, the peer is declared down and all routes received by this peer are withdrawn from the local BGP table. By default, the keepalive interval is set to 3 60 seconds and the hold time is set to 9 180 seconds. To decrease CPU load, especially in the presence of a lot of neighbors, you can increase the values of these timers or disable the exchange of keepalives entirely. When manually configuring new values, the keepalive interval can be less than or equal to one third of the hold time, but cannot be less than 1 second. Setting the keepalive and hold time values to 0 disables the exchange of keepalives.
...
Example
• This example set the hold time to 30 200 seconds.
| Code Block |
|---|
admin@XorPlus# set protocols bgp neighbor 2.2.2.2 timers holdtime 30200 admin@XorPlus# commit |