| Table of Contents | ||
|---|---|---|
|
Networking Requirements
Figure 1. Policy-Based Routing Configuration Example
...
Configure VLAN, VLAN interface and IP address on each switch to achieve network reachable. The configuration on the device Switch is provided in the following steps. Other devices have similar configurations and will therefore be ignored.
On Switch, configure match rule based on the source IPv4 address 192.168.10.10/24 (IP address of PC1) for PBR traffic classification.
On Switch, configure an action to redirect packets to a next-hop IP address 10.10.0.1/24 (IP address of Router 1) for policy-based routing.
On Switch, apply the PBR policy to the VLAN interface VLAN300 where the traffic from PC1 is coming in.
Procedure on Switch
Step 1 Configure VLANs and VLAN interfaces.
...
| Code Block |
|---|
admin@Switch# run show pbr map PBR_map1 Sequence: 100 match-condition: source-ipv4 192.168.10.10/32 dscp:0 action: nexthop 10.10.0.1 nexthop-vrf: dscp:0 statistics: vlan300: 1864 pkts |
...