Content Comparison

要配置交换机，需要先添加switch model? 需要增加add switch model 的原因，什么时候添加，在配置交换机之前？去UI 上确认如何添加。

To add Before you deploy switches, configure each switch model that you want to manage with AmpCon-DC. If not, the default port number ranges and built-in PicOS images are used to deploy switches with these switch models.

Configuring a Switch Model

To configure a switch model, follow these steps:

1. Click Service > System Model,

2. Click the + icon, and In the AmpCon-DC UI, click Service > Switch Model.

3. Optional: Refresh the supported switch model list:

   1. Click Update Switch Model.

   2. Click Yes to confirm the update.

...

3. In the Switch Model drop-down list, select the switch model that you want to configure.

4. Configure the port

...

1. Image Removed

...

Select the image that is used to install PICOS in switches during ZTP deployment. You need to upload the images beforehand as described in the Uploading and pushing images section.

3. number range for each speed.

4. In the Deployed ONIE Image drop-down list, select the PicOS image that you want to install for this switch model.

Note: If the PicOS image to install is not listed here, upload the PicOS image and its MD5 file to AmpCon-DC. For more information, see Uploading Images.

...

6. Click Save.

Optional:

...

Resetting a Switch Model

To reset a switch model, follow these steps:

1. In the AmpCon-DC UI, click Service > Switch Model.

2. Click Reset.

3. Click Save.

After you reset a switch model, the port number range for each speed is set to zero, and the PicOS image in the Deployed ONIE Image drop-down list is reset to the built-in image.