Versions Compared

Version Old Version 1 New Version Current
Changes made by

Tracy Yang

Tracy Yang

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Info
titleNOTEs:
  •   By default, 10G-Base-KR ports are disabled.
  •   There is a limitation when enabled the 10G-Base-KR ports as either front panel ports or management ports, namely:
    • On AS7726-32X, port xe-1/1/32 is not allowed to be split into four Gigabit Ethernet ports.
    • On AS7326-56X, port xe-1/1/8 is not allowed to be split into four Gigabit Ethernet ports.
  •   The interface rate of the two Me ports can only support auto-negotiation mode.

Introduction

AS7726-32X and AS7736AS7326-56X have two 10G-Base-KR ports (10G-KR) on the front panel to support additional high-speed link between CPU and ASIC (switch chip). PICOS supports to configure the two 10G-Base-KR ports as two 10G SFP+ front panel data ports or they can be configured to provide additional high speed links between the switch CPU and ASIC. 

...

Currently only AS7726-32X and AS7736AS7326-56X switches have the 10G-Base-KR ports which can be configured as two 10G SFP+ data ports on the front panel or as two 10G-KR management ports linked to CPU. By default, 10G-Base-KR ports are disabled.

Configuration

This section describes how to configure the two 10G-Base-KR ports as front panel ports or management ports linked to CPU.

...

  • From the Linux shell prompt, run sudo picos_boot management-port-mapping command to configure the 10G-Base-KR ports as two 10G-KR management ports linked to CPU. The default configuration is [3] No me Port(s)，indicating that the 10G-Base-KR ports are disabled.
Code Block
admin@PICOS:~$ sudo picos_boot management-port-mapping
    [1]  To Host CPU
    [2]  To Front Panel    
    [3]  No me Port(s)      * default
Enter your choice(1,2,3):1

 To Host CPU is selected.
Please restart the PICOS service

...