To configure the minimum delay between outbound RIP packets, use the set protocols rip interface vif address interpacket-delay command in L2/L3 configuration mode.

Command Syntax

set protocols rip interface interface-name vif vif-name address ip-address interpacket-delay time

Parameters

interface-name	Interface name
vif-name	Virtual interface name.
ip-address	Virtual interface IP address for RIP.
time	Minimum delay between outbound RIP packets, in ms (milliseconds).

Example

This example configures 10 ms as the minimum delay between outbound RIP packets:

admin@Switch# set protocols rip interface vlan10 vif vlan10 address 10.1.1.1 interpacket-delay 10

Browser not supported