The run show mlag link command displays MLAG link information.

Command Syntax

run show mlag link {<link-id>| summary}

Parameter

Parameter	Description
<link-id>	Specifies the MLAG link ID to show the specific MLAG information.
summary	Show MLAG information for all the MLAG links.

Example

Show the MLAG link information.

admin@XorPlus# run show mlag link summary
# of Links: 2
Link   Local LAG   Link Status   Local Status   Peer Status   Config Matched   Flood
----   --------   -----------   ------------   -----------   --------------   -----
1      ae1         IDLE          UP             UNKNOWN       No               No  
2      ae2         IDLE          UP             UNKNOWN       No               No

Table 1. Description of the run show mlag link command output

Item	Description
Link	Indicates the link ID of each MLAG.
Local LAG	Indicates the MLAG member port number on local MLAG device.
Link Status	Indicates MLAG interface state, the value could be INIT, IDLE, DOWN, STANDBY, AS_DOWN, AS_PEER, AS_LOCAL or FULL.
Local Status	Indicates the status of local MLAG member port, the value could be UP, DOWN or UNKNOWN.
Peer Status	Indicates the status of remote MLAG member port, the value could be UP, DOWN or UNKNOWN.
Config Matched	Indicates the consistency check results, the value could be Yes or No.
Flood	Indicates whether traffic received on the MLAG peer-link cannot be transferred through the MLAG member port. The value could be Yes or No. Yes: indicates that traffic received on the MLAG peer-link can be transferred through the MLAG member port. This happens only in the case when peer MLAG member port is down, the MLAG interface state changes to AS_LOCAL. No: indicates that traffic received on the MLAG peer-link cannot be transferred through the MLAG member port.

Browser not supported