set routing prefix-list

<ip4-prefix-name>

seq <sequence-number>

Specifies whether the route is available for further processing when there is a match. The value could be deny or permit.

• deny: In deny mode, if the IP address to be filtered is within the defined prefix range, the IP address fails to match the routing policy and cannot match the next entry.
• permit:  In permit mode, if the IP address to be filtered is within the defined prefix range, the IP address matches the routing policy and does not continue to match the next entry. 

{prefix <ipv4/prefixlen> | prefix-any}

Specifies an IP address/prefix length or all addresses. The value of prefix length is an integer that ranges from 0 to 32.

When prefix-any is specified, it creates a prefix-list that matches all addresses.

Optional. Specifies the lower threshold of the mask length. It can be used when an IP address/prefix length is specified.

If ge greater-equal-value and le less-equal-value are not specified, the value of mask-length is the mask length.

greater-equal-value must meet the following requirement: prefixlen ≤ greater-equal-value ≤ less-equal-value ≤ 32.

If only ge is configured, the mask ranges from greater-equal-value to 32.

Optional. Specifies the upper threshold of the mask length. It can be used when an IP address/prefix length is specified.

If ge greater-equal-value and le less-equal-value are not specified, the value of mask-length is the mask length.

less-equal-value must meet the following requirement: prefixlen ≤ greater-equal-value ≤ less-equal-value ≤ 32.

If only le is configured, the mask ranges from prefixlen to less-equal-value.