set firewall filter output routed-interface

To apply a filter to egress packets at a routed interface, use the set firewall filter output routed-interface command in L2/L3 configuration mode. To remove the filter, use the delete form of the command.

Command Syntax

set firewall filter filter-name output routed-interface routed-interface-name
delete firewall filter filter-name output routed-interface routed-interface-name

Parameters

filter-name	Filter name.
routed-interface-name	Routed interface name.

Example

This example applies the MyFilter filter to egress packets at the routed interface ge3:

admin@Switch# set firewall filter MyFilter output routed-interface ge3

This example removes the MyFilter filter from egress packets at the routed interface ge3:

admin@Switch# delete firewall filter MyFilter output routed-interface ge3
Deleting: 
>   ge3
OK