set firewall filter copp sequence from destination-address-ipv6

The set firewall filter copp sequence from destination-address-ipv6 command configures a firewall filter rule based on the destination IPv6 address for traffic classification.

Command Syntax

set firewall filter copp sequence <number> from destination-address-ipv6 <ipv6-address>

Parameter

Parameter

Description

sequence <number>

Specifies filter sequence number. The value is an integer that ranges from 0 to 9999.

The 18 integers 10, 20, 30, 40, 50, 60, 70, 80, 90, 100, 110, 120, 130, 140, 150, 160, 170, 180 are not allowed to be used for sequence numbers in user-defined CoPP firewall filter rules.

destination-address-ipv6 <ipv6-address>

Specifies destination IPv6, it could be a specific IPv6 address or an IPv6 subnet. The value is a 32-digit hexadecimal number, in the format X:X:X:X:X:X:X:X, an X contains 4 hexadecimal numbers. For example, aa00:1002::1, 2001::1/32.

Usage Guidelines

You can run the set firewall filter copp sequence from destination-address-ipv6 command to configure a firewall filter rule based on the destination IPv6 address for traffic classification so that the device processes packets matching the same firewall filter rule in the same manner.

Example

• Configure a firewall filter rule based on the destination IPv6 address of 2001::1/128.

admin@XorPlus# set firewall filter copp sequence 51 from destination-address-ipv6 2001::1/128
admin@XorPlus# commit