set firewall filter sequence from source-address-ipv6

To configure a filter sequence to match packets with specified destination IPv6 address, use the set firewall filter sequence from source-address-ipv6 command in L2/L3 configuration mode. To remove the condition, use the delete form of the command.

Command Syntax

set firewall filter filter-name sequence number from source-address-ipv6 address/prefix-length
delete firewall filter filter-name sequence number from source-address-ipv6

Parameters

filter-name	Filter name.
number	Filter sequence number. The range is 0-9999.
address/prefix-length	IPv6 address / prefix length.

Examples

The following example configures sequence 2 of the MyFilter filter to match packets with source IPv6 address is 2001::1:

admin@Switch# set firewall filter MyFilter sequence 2 from source-address-ipv6 2001::1/128

The following example removes the match condition from sequence 2 of the MyFilter filter:

admin@Switch# delete firewall filter MyFilter sequence 2 from source-address-ipv6 
Deleting: 
>   source-address-ipv6: 2001::1/128
OK