The set routing route-map match peer command matches the peer ip address. This is a BGP specific match command.
The delete routing route-map match peer command restores the default behavior of not matching the peer ip address if the BGP neighbor of the route.

Command Syntax

set routing route-map <route-map-name> order <NUMBER> match peer {ipv4-addr <ipv4-address>|ipv6-addr <ipv6-address> | local}

delete routing route-map <route-map-name> order <NUMBER> match peer {ipv4-addr <ipv4-address>|ipv6-addr <ipv6-address> | local}

Parameter

Parameter	Description
route-map <route-map-name>	Specifies the name of the route map. Required.
order <NUMBER>	Specifies the sequence number of the entry. Required. The value is an integer that ranges from 1 to 65535.
peer {ipv4-addr <ipv4-address>\|ipv6-addr <ipv6-address>\|local}	Specifies if the peer ip address if the BGP neighbor is matched with a match clause.

Example

Configure a match clause in the route map to match the peer ip address if the BGP neighbor:

admin@Xorplus# set routing route-map GlobalMap order 10 match peer ipv4-addr 100.100.100.1
admin@Xorplus# set routing route-map GlobalMap order 10 matching-policy permit
admin@Xorplus# commit

Browser not supported