set firewall filter sequence from protocol ip

To configure a filter sequence to match IP (Internet Porotocol) packets, use the set firewall filter sequence from protocol ip command in L2/L3 configuration mode. To remove IP packet matching from the filter sequence, use the delete form of the command.

Command Syntax

set firewall filter filter-name sequence number from protocol ip
delete firewall filter filter-name sequence number from protocol

Parameters

filter-name	Filter name.
number	Filter sequence number. The range is 0-9999.

Examples

The following example configures sequence 10 of the MyFilter filter to match IP packets:

admin@Switch# set firewall filter MyFilter sequence 10 from protocol ip

The following example removes the condition that matches IP packets from sequence 10 of the MyFilter filter:

admin@Switch# delete firewall filter MyFilter sequence 10 from protocol  
Deleting: 
>   protocol {
>       ip {
>       }
>   }
OK