The set protocols vrrp interface vrid command creates a VRRP group.

NOTE:

This command applies to both VRRPv2 and VRRPv3 configuration.

Command Syntax

set protocols vrrp interface <interface-name> vrid <virtual-router-id>

Parameter

Parameter	Description
interface <interface-name>	Specifies the Layer 3 interface name of VRRP device. The value could be the VLAN interface name, the routed interface or the sub-interface name. The value is a string.
vrid <virtual-router-id>	Specifies the VRID of a VRRP group. The value is an integer that ranges from 1 to 254.

Usage Guidelines

When configuring VRID, pay attention to the following points:

A VRID identifies the devices of the same VRRP group. Two devices in a VRRP group must be configured with the same VRID.

It is recommended that VRRP groups on different L3 interfaces of a device should be configured with different VRIDs.

One chassis switch supports a maximum of 128 VRRP groups. Please set the number of VRRP group based on device performance.

Example

admin@Xorplus# set protocols vrrp interface vlan100 vrid 2
admin@Xorplus# commit

Browser not supported