set management-ethernet-speed eth0

The set management-ethernet-speed eth0 command configures port speed of eth0 out-of-band management interface in operational mode.

Command Syntax

set management-ethernet-speed eth0 <10 | 100 | 1000 | auto>

Parameter

Null.

Example

Configure port speed of eth0 out-of-band management interface to 100Mbit/s and show the configuration result.

admin@PICOS> set management-ethernet-speed eth0 100
admin@PICOS> start shell sh
admin@PICOS:~$ sudo ethtool eth0
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supported pause frame use: Symmetric
        Supports auto-negotiation: Yes
        Supported FEC modes: Not reported
        Advertised link modes:  Not reported
        Advertised pause frame use: Symmetric
        Advertised auto-negotiation: No
        Advertised FEC modes: Not reported
        Speed: 100Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 2
        Transceiver: internal
        Auto-negotiation: off
        MDI-X: Unknown