The run show routed interface command shows the detailed layer 3 interface information of a specific routed interface or sub-interface.

Command Syntax

run show l3-interface routed-interface <interface-name>

Parameter

Parameter	Description
routed-interface <interface-name>	Specifies a routed interface name or sub-interface name. The value is a string.

Example

View the detailed layer 3 information of a specific routed interface.

admin@Xorplus# run show l3-interface routed-interface rif-te1
rif-te1          Hwaddr 18:5A:58:1F:63:A1, Vlan:800, MTU: 1500, State:UP 
                 Inet addr: 120:1:1::49/64
                            fe80::1a5a:5820:131f:63a1/64
                 Traffic statistics:
                   5 sec input rate IPv4 0 packets/sec, IPv6 0 packets/sec
                   5 sec forwarding rate IPv4 0 packets/sec, IPv6 0 packets/sec
                   IPv4 Input Packets............................0
                   IPv4 Forwarding Packets.......................0
                   IPv6 Input Packets............................0
                   IPv6 Forwarding Packets.......................0

Browser not supported