The set interface gigabit-ethernet routed-interface name command configures the name for the routed interface, which will be referred to in other CLI commands as the routed interface name.

Command Syntax

set interface gigabit-ethernet <interface-name> routed-interface name <string>

Parameter

Parameter	Description
gigabit-ethernet <interface-name>	Specifies a physical port name. The value is like ge-1/1/1, te-1/1/3, etc.
name <string>	Specifies the name for the routed interface. The value could be up to 15 alphanumeric characters (including three special characters . – and @). NOTE: To avoid conflict with the preserved interface names, the routed interface name and sub-interface name must start with the string "rif-". Otherwise, commit will fail with the error message "The name of interface must start with "rif-".

Parameter

Description

gigabit-ethernet <interface-name>

Specifies a physical port name. The value is like ge-1/1/1, te-1/1/3, etc.

name <string>

Specifies the name for the routed interface. The value could be up to 15 alphanumeric characters (including three special characters . – and @).

NOTE:

To avoid conflict with the preserved interface names, the routed interface name and sub-interface name must start with the string "rif-". Otherwise, commit will fail with the error message "The name of interface must start with "rif-".

Example

Configure the name for the routed interface.

admin@Xorplus# set interface gigabit-ethernet te-1/1/4 routed-interface enable true
admin@Xorplus# set interface gigabit-ethernet te-1/1/4 routed-interface name rif-te4 
admin@Xorplus# commit

Browser not supported