To install You can install the AmpCon-DC server on a physical machine based on Ubuntu 22.04 by using the AmpCon-DC server installation package.
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Prerequisites
Before you install the AmpCon-DC server, ensure that the following prerequisites are met:
The installation requirements are met.
You have a physical machine based on Ubuntu 22.The 04 with Docker installed.
You have downloaded the AmpCon-DC server installation package is downloaded.
...
by going to the FS AmpCon-DC website
...
and then clicking AmpCon™-DC for
...
Ubuntu Docker 2.1.0 Software
...
in the Resources section.
Installation Procedure
Unzip the AmpCon-DC server
...
- AmpCon™-DC for VirtualBox 2.1.0 Software
...
installation package by running the following command:
tar -zxvf <AmpCon-DC server |
|---|
...
- AmpCon™-DC for Ubuntu Docker 2.1.0 Software
...
installation package name> |
|---|
Go to the directory where the AmpCon-DC server
...
- AmpCon™-DC for GNS3 2.1.0 Software
...
installation package exists.
...
Install the AmpCon-DC server
...
Installing in VirtManager
Download the AmpCon-DC QCOW2 image as described in the Prerequisite section.
...
Run the following command to open the Virtual Manager interface:
virt-manager |
|---|
Click the button as follows to import the virtual machine.
...
Select "import existing disk image" and click "Forward".
...
Click "Browse" to select the local image file.
...
Click "Browse Local" to add a local location
...
Find the actual qcow2 mirror location and click "Open"
Click "Forward"
Click "Forward"
...
Adjust the virtual machine configuration as needed and click "Forward"
In the
...
In the Network section, select Host device ens160: macvtap and click "Finish"
...
Wait for the creation to complete, automatically enter the virtual machine serial command line, the import is complete
Modify configuration settings
Enter username and password: pica8/pica8
Enter the command “sudo vi /etc/netplan/00-installer-config.yaml” to modify the IP address
Enter the command “sudo netplan apply” to apply the network interface configuration
...
by running the following command:
sudo ./install_or_upgrade.sh |
|---|
Start the AmpCon-DC server by running the following command:
cd /usr/share/automation/server && sudo ./start. |
|---|
...
Page Authentication
Enter the IP address of AmpCon™-DC in the browser
...
sh |
|---|
What to Do Next
After you install the AmpCon-DC server, you need to import the AmpCon-DC License, and add system configurations.