...
...
...
...
...
...
...
...
| Info |
|---|
This command is not available for N32xx series N32xx and N22xx series switches. |
The set poe power management-mode command configures PoE power management-mode on all the ports or on a specific ethernet port.
...
<value>: The value is an integer. For AS4610-30P, AS4610-54P, AS4630-54PE and AS4630-54NPE. the value ranges from 1 to 4. For other PoE supported switches, the value ranges from 1 to 6. The default value is 1.
...
- Supported only on all the PoE supported switches except AS4610-30P, AS4610-54P, AS4630-54PE and AS4630-54NPE.
Caculate the total allocated max power for all ports by the PD class, the class max power values are as follows:
Class 0: 15.4W
Class 1: 4W
Class 2: 7W
Class 3: 15.4W
Class 4: 32W (64W, for UPoE port）
- When available power is less than the maximum power threshold configured or the port and the port priority is greater than the priority of currently powered ports, the PoE controller disconnects the low priority ports and allows the port to power up.
...
- Supported only on all the PoE supported switches except AS4610-30P, AS4610-54P, AS4630-54PE and AS4630-54NPE.
Caculate the total allocated max power for all ports by the PD class, the class max power values are as follows:
Class 0: 15.4W
Class 1: 4W
Class 2: 7W
Class 3: 15.4W
Class 4: 32W (64W, for UPoE port）
- When the available power is less than the maximum power threshold configured on the port, the PoE controller does not allow power on this port since port priority is not taken into effect, lower priority ports are not disconnected to power higher priority ports.
...