Before you deploy switches, configure each switch model that you want to manage with AmpCon-CampusampusCampus. If not, the default port number ranges and built-in PicOS images are used to deploy switches with these switch models.
| Table of Contents | ||
|---|---|---|
|
Prerequisite
Click Service > Switch Model in the AmpCon-Campusampus UI, and then check whether the PicOS image to install is listed in the Deployed ONIE Image drop-down list.
...
...
If the image is listed there, you don’t need to upload the PicOS image and its MD5 file.
Configuring a Switch Model
To configure a switch model, follow these steps:
In the AmpCon-Campusampus Campus UI, click Service > Switch Model.
Optional: Refresh the supported switch model list:
Click Update Switch Model.
Click Yes to confirm the update.
...
Note: If the PicOS image to install is not listed here, upload the PicOS image and its MD5 file to AmpCon-CampusampusCampus. For more information, see Uploading Images.
...
Click Save.
Optional: Resetting a Switch Model
To reset a switch model, follow these steps:Note:
In the AmpCon-Campus UI, click Service > Switch Model.
Click Reset.
Click Save.
After you reset a switch model, the port number range for each speed is set to zero, and the PicOS image in the Deployed ONIE Image drop-down list is reset to the built-in image.
...
In the AmpCon-Campusampus UI, click Service > Switch Model.
...
Click Reset.
...
.