Run the command set protocols ospf network area to configure OSPF instance for the IP subnet prefix with an area address per network. The optional parameter vrf can be used to specify OSFP instance for a particular VRF. If VRF is not defined then OSPF instance takes effect for the default VRF.
Run the command delete protocols ospf network area to delete this configuration.
Command Syntax
set protocols ospf [vrf <vrf-name>] network <ipv4/prefixlen> area {<ipv4|<area-id>}
delete protocols ospf [vrf <vrf-name>] network <ipv4/prefixlen> area {<ipv4>|<area-id>}
Parameter
Parameter | Description |
vrf <vrf-name> | Optional. Specifies the name of the VRF for the OSPF instance. |
| network <ipv4/prefixlen> | Specifies the network prefix and prefix length in IPv4 format. |
| area {<ipv4>|<area-id>} | Specify OSPF area, the value could be in IPv4 dotted decimal format or an integer ranging from 0 to 4294967295. |
Example
- Enable OSPF for network 10.0.0.0/16 in VRF BLUE and specify area 1.1.1.1.
admin@XorPlus# set protocols ospf vrf BLUE network 10.0.0.0/16 area 1.1.1.1 admin@Xorplus# commit