To configure tunneling for egress traffic, use the set vlans dot1q-tunneling egress from command in L2/L3 configuration mode. If the customer VLAN or service VLAN tag frame is specified, it can pass through the port.

Command Syntax

set vlans dot1q-tunneling egress tunnel-id then { customer-vlan | service-vlan } vlan-id

Parameters

tunnel-id	Tunnel identifier.
customer-vlan	The customer VLAN identifier.
service-vlan	The service VLAN identifier.
vlan-id	VLAN identifier. The range is 0-4094.

Examples

This example configures tunneling T0, such that if the customer tag frame is 10 and the service tag frame is 100, the packet can pass through the port:

admin@Switch# set vlans dot1q-tunneling egress T0 from customer-vlan 10
admin@Switch# set vlans dot1q-tunneling egress T0 from service-vlan 100

Browser not supported