copy running-config startup-config

The copy running-config startup-config command saves the running configuration file from the RAM to the flash.

Command Syntax

copy running-config startup-config

Parameter

None.

Usage Guidelines

When performing the following operations, you need to manually issue the configuration saving command to save the configuration file from the RAM to the flash.

•   Perform picos_boot
•   Set L2 / L3 CLI commands (for the L2 / L3 CLI configuration, you need to issue the commit command before saving the configuration to flash)
•   Set OVS commands
•   Set CrossFlow commands

You can use two commands to save your configuration, the save_config command or the copy command:

•  Under Linux bash, issue the following command manually (When setting OVS commands, you can only use this command to save the configuration file):

admin@Xorplus$ sudo save_config

•  In the L2 / L3 CLI operating mode, issue the following command manually:

admin@Xorplus> copy running-config startup-config

Example

•  Save the running configuration file from the RAM to the flash after setting the L2 / L3 CLI commands.

admin@Xorplus# set protocols vrrp interface vlan100 vif vlan100 vrid 2 disable true
admin@Xorplus# set protocols vrrp interface vlan100 vif vlan100 vrid 2
admin@Xorplus# commit
Merging the configuration.
Commit OK.
Save done.
admin@Xorplus# quit
admin@Xorplus> copy running-config startup-config