This chapter describes the configuration steps of Layer 2 switching, including MAC address learning, LLDP, LACP, 802.1Q VLAN, flow control, mirroring, storm control, and the Spanning Tree Protocol (STP/RSTP/MSTP).

Static MAC entries and Dynamic MAC Address Learning
Cut-Through Switching Method
MLAG Configuration
- Principle of MLAG
- Configuration Notes and Constraints
- Configuring MLAG
- Configuration Example of MLAG
- MLAG Maintenance and Troubleshooting
VLAN Port Configuration
Q-in-Q Basic Port Configuration
Private VLAN Configuration Guide
- Introduction of PVLAN
- Configuration Notes of PVLAN
- Configuring PVLAN
- Example for Configuring PVLAN
Voice VLAN Configuration Guide
- Principle of Voice VLAN
- Configuration Notes of Voice VLAN
- Configuring Voice VLAN
- Configuration Example of Voice VLAN
Link Aggregation Configuration
- Static Link Aggregation (LAG) Configuration
- Link Aggregation Control Protocol (LACP) Configuration
- LAG Hashing Configuration
Symmetric Hash for LAG Configuration Example
LLDP Configuration (Link Layer Discovery Protocol)
LLDP MED Configuration
MSTP Configuration
MSTP Configuration Example
Rapid PVST+ Configuration
Rapid PVST+ Configuration Example
BPDU Tunneling Configuration
UDLD Configuration
LFS Configuration
Storm Control in Ethernet Port Configuration
IGMP Snooping Configuration Guide
- Introduction to IGMP Snooping
- Configuring IGMP Snooping
- Configuration Example of IGMP Snooping
- RFC List

Browser not supported