N3132PX-ON

Front Panel Schematic

(1) Temp LED	(2) Power 1 LED	(3) Status LED
(4) Master LED	(5) Power 2 LED	(6) FAN Status LED
(7)1G RJ45 port	(8) 2.5G/5G RJ45 port	(9) SFP+ port
(10) USB port	(11) RJ45 Console port	(12) Management Ethernet port
(13) Reset button	(14)7-DIGIT Stack LED	-

Rear Panel Schematic

(1) PSU(Power Supply Unit)	(2) PSU LED	(3) FAN1
(4) FAN2	(5) QSFP MODULE port	-

Switch System Characteristics

Mechanical dimension	Standard 1U chassis high
Management port	1
RJ45 Console port	1
RJ45 port	24
2.5G/5G RJ45 port	8
SFP+ port	4
*QSFP MODULE port	2
7-DIGIT Stack LED	1
Temp LED	1
Power 1 LED	1
Power 2 LED	1
Status LED	1
Master LED	1
FAN Status LED	1
USB port	1
Reset button	1
PSU	2
FRU(Fan Removable Unit)	2
Working environment temperature	0ºC～75ºC

*UPoE

The RJ45 ports of the switch, namely, ge-1/1/1 - ge-1/1/32 on the front panel of N3132PX support UPoE. For these UPoE ports, the maximum output power can be set to up to 65 watts. For details about UPoE, please refer to UPoE.

*QSFP MODULE port

N3132PX has one slot for QSFP module at the rear side. The module slot can be plugged in 2 x 40G QSFP modules. The port numbers of the QSFP module are xe-1/1/1 and xe-1/1/2.

NOTE:

The 2.5G/5G RJ45 ports don’t support to set the force speed by using set interface gigabit-ethernet<interface-name> speed <speed> command. Users can configure auto-negotiation mode to auto-negotiate the interface rate for these ports, together with the optional set interface gigabit-ethernet <interface-name> auto-speeds <auto-speed> command to manually specify the auto-negotiation rate range.

The QSFP ports at the rear side cannot be split into four 10G interfaces.

It requires restarting the system when you plug-in or plug-out the module slot.

Delete the user configuration files /pica/config/pica_startup.boot and /pica/config/pica.conf when you plug out the module slot and before restarting PICOS.