This chapter describes the configuration steps of Layer 2 switching, including MAC address learning, LLDP, LACP, 802.1Q VLAN, flow control, mirroring, storm control, and the Spanning Tree Protocol (STP/RSTP/MSTP).

Static MAC entries and Dynamic MAC Address Learning
Cut-Through Switching Method
MLAG Configuration
- Principle of MLAG
- Configuration Notes and Constraints
- Configuring MLAG
- Configuration Example of MLAG
- MLAG Maintenance and Troubleshooting
VLAN Configuration
- Configuring Port-based VLAN
- Configuring MAC-based VLAN
- MAC Trace
GVRP
- Overview of GVRP
- Configuring GVRP
- Example for Configuring GVRP
MVRP
- Overview of MVRP
- Configuring MVRP
- Example for Configuring MVRP
Q-in-Q Basic Port Configuration
Private VLAN Configuration Guide
- Introduction of PVLAN
- Configuration Notes of PVLAN
- Configuring PVLAN
- Example for Configuring PVLAN
- Example for Configuring DHCP Snooping with PVLAN
Voice VLAN Configuration Guide
- Principle of Voice VLAN
- Configuration Notes of Voice VLAN
- Configuring Voice VLAN
- Configuration Example of Voice VLAN
Link Aggregation Configuration
- Static Link Aggregation (LAG) Configuration
- Link Aggregation Control Protocol (LACP) Configuration
- LAG Hashing Configuration
- LACP Fallback
- Configuring LACP Fast Rate
- LAG Specification of Different Platforms
Symmetric Hash for LAG Configuration Example
LLDP Configuration (Link Layer Discovery Protocol)
LLDP MED Configuration
MSTP Configuration
MSTP Configuration Example
Rapid PVST+ Configuration
Rapid PVST+ Configuration Example
BPDU Tunneling Configuration
UDLD Configuration
LFS Configuration
Storm Control in Ethernet Port Configuration
Ethernet Ring Protection Switching (ERPS)
- Overview of ERPS
- Configuration Notes and Constraints of ERPS
- Configuring ERPS
- Example for Configuring ERPS

Browser not supported