AS5812-54T Switch

·System LED Definition：

Label	Condition	Description
PS1 (Power Supply Status)	Green	This power is operating normally.
	Amber	PWR present but not power on or this power is fault.
	Off	Power supply not present.
PS2 (Power Supply Status)	Green	This power is operating normally.
	Amber	PWR present but not power on or this power is fault.
	Off	Power supply not present.
Diag	Green	System self-diagnostic test successfully completed.
Diag	Amber	System self-diagnostic test has detected a fault. (Fan, thermal or any interface fault.)
FAN	Green	System FAN operating normally.
	Amber	Fan tray present buy system FAN is fault.
	OFF	System OFF
LOC	Not supported.

·port LED Definition：

LED	Condition	Status
1~48 Port LED	On/Flashing Green	Port has a valid link at 10G. Flashing indicates activity.
	On/Flashing Amber	Port has a valid link at 1G/100M. Flashing indicates activity.
	Off	There is no link on the port.
QSFP+ Port LED in 40G Mode (Port 49~ 54)	On/Flashing Green	SFP+ port has a valid link at 40G. Flashing indicates activity.
QSFP+ Port LED in 40G Mode (Port 49~ 54)	Off	There is no link on the port.
QSFP+ Port LED in 10G Mode (With Breakout cable)	On/Flashing Green	QSFP port has a valid link at 10G via break out cable. The LED on 40G QSFP end is also present OFF. Flashing indicates activity.
QSFP+ Port LED in 10G Mode (With Breakout cable)	Off	There is no link on the port.
OOB LED (Link)	On	Port has a valid link
OOB LED (Link)	Off	There is no link on the port
OOB LED (Activity)	Flashing	Flashing indicates activity
OOB LED (Activity)	Off	There is no link on the port

Single-color LED will be used for 40G QSFP+ uplink port to indicate link/activity.
There should be four LEDs per QSFP port. These LEDs can represent state of 40GE port or 4 10GE ports when used in breakout mode.
The 40G QSFP+ LED should present OFF while there’s breakout cable plugged in.