show interface detail

This command show interface detail information.
Command Syntax
run show interface detail
Example
• This example is to show detail information of interface :
admin@XorPlus# run show interface detail 
Physical interface: ge-1/1/1, Enabled, error-discard False, Physical link is Up
Interface index: 1, SFP type: Unknown
Port mode: access
Description: 
Link-level type: Ethernet, MTU: 1514, Speed: 100Mb/s, Duplex: Full
Source filtering: Disabled, Flow control: Disabled, Auto-negotiation: Enabled
Interface flags: Hardware-Down SNMP-Traps Internal: 0x0
Interface rate limit ingress:100, egress:100
Current address: 08:9e:01:a8:00:49, Hardware address: 08:9e:01:a8:00:49
Traffic statistics:
5 sec input rate 0 bits/sec, 0 packets/sec
5 sec output rate 392 bits/sec, 0 packets/sec
Input Packets............................99114129
Output Packets...........................57388
Input Octets.............................6343304256
Output Octets............................7021889
Transmit:
Unicast packets........................0
Multicast packets......................57388
Broadcast packets......................0
Packets 64 Octets......................0
Packets 65-127 Octets..................55264
Packets 128-255 Octets.................2124
Packets 256-511 Octets.................0
Packets 512-1023 Octets................0
Packets 1024-1518 Octets...............0
Oversize Packets.......................0
Total Packets Without Errors...........57388
Discarded Packets......................0
Total Packets With Errors..............0
Single Collision Frames................0
Multiple Collision Frames..............0
Deferred Frames........................0
Late Collisions........................0
Excessive Collisions...................0
Pause Frames...........................0
Receive:
Unicast packets........................99114129
-More-