set protocols snmp trap-group targets security-name

The set protocols snmp trap-group targets security-name command configures NMS for receiving the trap messages.

Please note trap-messages can be actually sent out only if the concerning user, group and notify-view have been configured.

Command Syntax
set protocols snmp trap-group targets <IPv4_address> security-name <security-name>
delete protocols snmp trap-group targets <IPv4_address> security-name

Parameter

Parameter

Description

targets <IPv4_address>

Specifies the address of the target host that receives SNMP traps.

NOTE:
The IP address specified by address and the security name specified by securityname together identify a target host.

security-name <security-name>

Specifies the user security name displayed on the NMS.

For SNMPv3, security name must be configured as the user name. security name configured on the host needs to be the same as that configured on the NMS, or the NMS cannot receive the trap messages sent from the host.

For SNMPv1 and SNMPv2c, the NMS can receive trap messages from all hosts without having security name configured. security name is used to distinguish multiple hosts that generate trap messages.

Example

•This example configures a NMS for receiving the trap messages.

admin@XorPlus# set protocols snmp trap-group targets 10.10.51.42 security-name user1  
admin@XorPlus# commit

PICOS-4.4.4_Configuration_Guide (Special Release)

set protocols snmp trap-group targets security-name

Analytics

Related content