FS S3410 Series Switch Unsupported Features and Limitations

The following L2/L3 features are not supported on S3410 Series switches:

• not support IS-IS

• not support OSPFv2/OSPFv3 GR

• not support IPv6 Source Guard

• not support IPv6 DHCP Guard

• not support IPv6 DHCP Snooping

• not support PFC Watchdog

• not support ECMP Hash Mode (Randomized Load Balance, Round-Robin Load Balance and Dynamic Load Balance Normal Mode)

• not support L3 GRE

• not support VXLAN

• not support IGMP

• not support PIM

• not support buffer dynamic shared for egress multicast queue

• not support symmetric hash

• not support resilient hash

• not support advance hash

• not support PFC (Priority Flow Control)

• not support ECMP

• not support NETCONF

• not support VRF

• not support CoPP max bandwidth and min bandwidth configuration

S3410 Series switches do not support OVS (Open vSwitch).

S3410 Series switches do not support CrossFlow.

S3410 Series switches do not support installing through USB.

The commands sudo systemctl stop picos and sudo systemctl restart picos are not supported on S3410 Series switches.

S3410 Series switches do not have an Eth0 management port; instead, an in-band management port is used. By default, the in-band management function of all the service port is enabled on VLAN 1 with a system built-in interface name inband-mgmt. For more details, see document Default Settings for In-Band Management Interface on S3410 Series Switches .

The loopback port cannot establish BGP neighbors, resulting in routing function cannot work on S3410 Series switches.