Installing PICOS for FS S3410 Series Switches 1

PICOS system can be installed under the Uboot menu through TFTP protocol for FS S3410 Series switches. The following steps describe the installation procedure.

Step 1 Power off and on to force restarting the switch, then press Ctrl+C to enter Uboot menu.

Step 2 Enter 0 and then 1 in the Uboot menu to perform the installation process.

Step 3 Use TFTP protocol to download the installation files, and then install PICOS.

a) Configure the TFTP parameters. Local IP is the management interface IP of the switch, Remote IP is the IP of the TFTP server, Filename is the installation image directory and name located on the TFTP server.

b) After downloaded the installation image successfully, you need to input Y manually, then the system will automatically start system installation process.

c) Wait a few minutes before the installation process is completed. When Success is displayed, it indicates that the installation process is successfully completed.

Step 4 Press Ctrl+Z to go back to the Uboot menu, then type 2 to reboot the switch.

Then the device reboots and comes up running the new network operating system.

Users need to enter the username and password after the system restarts, the initial login username is admin and password is pica8. Then users will be asked to set a new password for admin. This is the only post installation step after which the PICOS operating system can be used.