show interface gigabit-ethernet

This command is to show information about the specified gigabit-ethernet interface

Command Syntax
run show interface gigabit-ethernet <interface>

Parameter
•<interfce> a specified interface identifier,[ge-1/1/1...ge-1/1/48],[te-1/1/49...te-1/1/52]

Example
• This example is to show information of ge-1/1/1:

admin@XorPlus# run show interface gigabit-ethernet ge-1/1/1
Physical interface: ge-1/1/1, Enabled, error-discard False, Physical link is Up
Interface index: 1, SFP type: Unknown
Description: 
Link-level type: Ethernet, MTU: 1514, Speed: 100Mb/s, Duplex: Full
Source filtering: Disabled, Flow control: Disabled, Auto-negotiation: Enabled
Interface flags: Hardware-Down SNMP-Traps Internal: 0x0
Interface rate limit ingress:100, egress:100
Current address: 08:9e:01:a8:00:49, Hardware address: 08:9e:01:a8:00:49
Traffic statistics:
5 sec input rate 0 bits/sec, 0 packets/sec
5 sec output rate 0 bits/sec, 0 packets/sec
Input Packets............................99114129
Output Packets...........................83553
Input Octets.............................6343304256
Output Octets............................10240184