protocols ospf6 area interface vif hello-interval

To configure the OSPFv3 hello interval on an interface, use the set protocols ospf6 area interface vif hello-interval command in L2/L3 configuration mode.

Command Syntax

set protocols ospf6 area area-id interface interface-name vif name hello-interval time

Parameters

area-id	The OSPF area to which the attached network belongs.
interface-name	Interface name to be included in the OSPFv3 area specified by area-id.

time	The time between two consecutive Hello messaged. The range is 1-65535.

Example

The following example configures an OSPFv3 hello interval of 20 seconds on the vlan2000 interface:

admin@XorPlus# set protocols ospf6 area 0.0.0.0 interface vlan2000 vif vlan2000 hello-interval 20