set system aaa radius source-interface

Owned by Tracy Yang
Nov 13, 2023

The set system aaa radius source-interface command sets the source interface the switch uses to connect to the RADIUS server.


Command Syntax

set system aaa radius source-interface <interface-name>


Parameter

Parameter

Description

interface <interface-name>

Specifies the source interface. The value could be an L3 VLAN interface, loopback interface, routed interface or sub-interface that enabled inband management or eth0. By default, the source interface is eth0.


Usage Guidelines

NOTE:

  • When using a L3 VLAN interface, loopback interface, routed interface or sub-interface as a source interface connecting to the RADIUS server, you have to enable inband management function by using commands set system inband vlan-interface <vlan-interface>, set system inband loopback <loopback-interface>, set system inband routed-interface <routed-interface>.
  • Remember to specify an IP address for the source interface.


Example

  • Set the source interface the switch uses to connect to the RADIUS server to loopback interface.
admin@Xorplus# set l3-interface loopback lo address 10.1.1.1 prefix-length 32
admin@Xorplus# set system aaa radius source-interface loopback
  • Set the source interface the switch uses to connect to the RADIUS server to L3 VLAN interface.
admin@Xorplus# set interface gigabit-ethernet ge-1/1/23 family ethernet-switching native-vlan-id 100
admin@Xorplus# set l3-interface vlan-interface vlan100 address 10.10.51.129 prefix-length 24
admin@Xorplus# set vlans vlan-id 100 l3-interface vlan100
admin@Xorplus# set system inband vlan-interface vlan100
admin@Xorplus# set system aaa radius source-interface vlan100

Copyright © 2024 Pica8 Inc. All Rights Reserved.