run show dot1x server

The run show dot1x server command displays the reachability of the AAA servers configured on the switch.

Command Syntax

run show dot1x server

Parameter

None.

Example

Run run show dot1x server command to view reachability of the RADIUS servers.

admin@Xorplus# run show dot1x server 
Server-IP         Status        Priority  Retry-Interval  Retry-Num  Detect-Interval   Consecutive-Detect-Num  
----------------  ------------  --------  --------------  ---------  --------------    ----------------------  
10.10.53.72       reachable     ...       5   Sec(s)      5          5   Sec(s)        8

Table 1. Description of the run show dot1x server command output

Item	Description
Server-IP	Indicates the RADIUS Server IP configured on the switch.
Status	Indicates whether the RADIUS server is reachable. The value could be active, reachable or unreachable. If the server is reachable and currently selected for NAC authentication, the “Status” of this server is active.
Priority	Indicates the priority of AAA server. The value is an integer that ranges from 1 to 3. Priority of 1 is higher than 3. “...” indicates a lowest priority if not configured for the AAA server. Note: The AAA servers are listed in the order of priority.
Retry-Interval	Indicates the interval for re-sending the authentication messages to the AAA server when the AAA server does not respond during NAC authentication.
Retry-Num	Indicates the maximum number of authentication attempts when the AAA server does not respond during NAC authentication.
Detect-Interval	Indicates the interval at which the switch sends Test Radius Request detection message to the AAA server to detect the server reachability.
Consecutive-Detect-Num	Indicates the number of Test Radius Request messages that the switch consecutively sends to the AAA server to detect the server reachability.