set vlans dot1q-tunneling egress from
To configure tunneling for egress traffic, use the set vlans dot1q-tunneling egress from command in L2/L3 configuration mode. If the customer VLAN or service VLAN tag frame is specified, it can pass through the port.
Command Syntax
set vlans dot1q-tunneling egress tunnel-id from { customer-vlan | service-vlan } vlan-id
Parameters
tunnel-id | Tunnel identifier. |
customer-vlan | The customer VLAN identifier. |
service-vlan | The service VLAN identifier. |
vlan-id | VLAN identifier. The range is 0-4094. |
Examples
This example configures tunneling T0, such that if the customer tag frame is 10 and the service tag frame is 100, the packet can pass through the port:
admin@Switch# set vlans dot1q-tunneling egress T0 from customer-vlan 10 admin@Switch# set vlans dot1q-tunneling egress T0 from service-vlan 100
Copyright © 2024 Pica8 Inc. All Rights Reserved.