Configuring the Force Rate of an Interface

This section describes how to configure the force rate of an interface.

Procedure

Configure the force rate of an interface.

set interface gigabit-ethernet<interface-name> speed <speed>

Configuration Example

Configure the force rate of the Te-1/1/5 port to 100 M.

admin@Xorplus# set interface gigabit-ethernet te-1/1/5 speed 100
admin@Xorplus# commit

Verify the Configuration

Use run show interface gigabit-ethernet command to view the current interface status information of te-1/1/5 interface. Check the Speed and Auto-negotiation field in the command output. Auto-negotiation field is Disabled when in non-auto-negotiation mode.

admin@XorPlus# run show interface gigabit-ethernet te-1/1/5
Physical interface: te-1/1/5, Enabled, error-discard False, Physical link is Up
Interface index: 5, SFP type: unknown, Mac Learning Enabled
Port mode: access
Description:
Link-level type: Ethernet, MTU: 1514, Speed: 1Gb/s, Duplex: Full
Source filtering: Disabled, Flow control: Disabled
Auto-negotiation: Disabled
Interface flags: Hardware-Down SNMP-Traps Internal: 0x0
Interface rate limit  ingress:unlimited, egress:unlimited
Link fault signaling  ignore local fault:false, ignore remote fault:false
force up mode:false
Precision Time Protocol mode:none
Current address: 48:6e:73:01:00:bb, Hardware address: 48:6e:73:01:00:bb
Traffic statistics:
  5 sec input rate 0 bits/sec, 0 packets/sec
  5 sec output rate 544 bits/sec, 0 packets/sec
  Input Packets............................0
  Output Packets...........................9149
  Input Octets.............................0
  Output Octets............................1125327