Atrium Specific Configuration

1. Enable multi-table on PicOS. Table 252 is the FDB for IP entries. The preference setting instructs the switch to prioritize match on FDB entries over TCAM.

admin@PicOS-OVS$ ovs-vsctl set-l3-mode TRUE 252

admin@PicOS-OVS$ ovs-vsctl set-l2-l3-preference TRUE

 Verify multi-tables are enabled.

 admin@PicOS-OVS$ovs-vsctl show-l2-l3-preference

  l2/l3 flow preference is enabled

admin@PicOS-OVS$ovs-vsctl show-l3-mode         

  l3 mode is enabled, table id is 252

2. Next, create a bridge. Using the GUI is the easiest way: point a browser to the switch management port IP address, use the configuration tab, click on the "Create a bridge" button, and give the bridge a name.

3. Click on the newly created bridge and then "Basic Info". Hit the Edit button. Give a Datapath ID (same one configured in ONOS). Select OpenFlow version 13. The fail mode does not matter.

4. Add a new controller: tcp, out-of-band, <controller-IP> and port 6633

5. Add as many ports as wanted to the bridge. Select the port number. Select TRUNK mode (important). Don't worry about the Tag/Trunk and there is no Flow Control.

Step 6: Finally, remember to use the routerMac: 08:9e:01:82:38:68 for all ports when doing configuration in the controller (in addresses.json and router-deploy.py)

Step 7: Verify the appropriate flows have been installed