Configuring the NTP Server IP Address

The L2/L3 switch synchronizes with the NTP server only when the configuration commands are committed using the commit command. User can change the NTP server's IP address, as shown below.

admin@XorPlus# set system ntp server-ip 192.168.10.100
admin@XorPlus# commit 
Waiting for merging configuration.
Commit OK.
Save done.
admin@XorPlus#

Configuring the NTP Source Interface

NTP source interface is required if inband management interface is used to connect with the NTP server.

admin@XorPlus# set system ntp source-interface vlan-300
admin@XorPlus# commit 
Waiting for merging configuration.
Commit OK.
Save done.
admin@XorPlus#

Configuring the Time Zone

Configure the time zone as follows (The time zone configured below is Pacific/Kosrae).

admin@XorPlus# set system timezone Pacific/Kosrae
admin@XorPlus# commit 
Waiting for merging configuration.
Commit OK.
Save done.
admin@XorPlus# 

Configuring the System Clock

admin@XorPlus> set date 2012.01.01-23:59
Sun Jan 1 23:59:00 UTC 2012
admin@XorPlus>

The clock will be set in the hardware.