set interface gigabit-ethernet rate-limiting egress burst


The set interface gigabit-ethernet rate-limiting egress burst command sets a burst limit value on a port for the egress traffic.


Command Syntax

set interface gigabit-ethernet  <interface-name> rate-limiting egress burst <burst-size>


Parameter

Parameter

Description

interface <interface-name>

Specifies an interface name. The value is a string.

burst <burst-size>

Specifies the burst size in kbit, which is the maximum volume of burst traffic that can pass through an interface. The value is an integer from 1 to the value of interface rate.

When burst size is not configured, PICOS uses a burst size adapted according to the configured rate limiting value configured by the set interface gigabit-ethernet <interface-name> rate-limiting egress kilobits <value> or set interface gigabit-ethernet <interface-name> rate-limiting egress ratio <value> command.


Example

  •   Set the burst size value to 10 kbit on port ge-1/1/1 for the egress traffic.
admin@Xorplus# set interface gigabit-ethernet ge-1/1/1 rate-limiting egress burst 10
admin@Xorplus# commit

Copyright © 2024 Pica8 Inc. All Rights Reserved.