set protocols mlag domain peer-ip peer-vlan
The set protocols mlag domain peer-ip peer-vlan command configures an MLAG peer VLAN.
Command Syntax
set protocols mlag domain <domain-id> peer-ip <peer-ipv4-address> peer-vlan <vlan-id>
Parameters
Parameter | Description |
domain <domain-id> | Specifies a domain ID. The value is an integer that ranges from 1 to 255. |
peer-ip <peer-ipv4-address> | The IP address of the remote MLAG peer-link port. The value is in dotted decimal notation. |
peer-vlan <vlan-id> | Specifies a peer VLAN ID. The value is an integer that ranges from 1 to 4094. The recommended value is 4088. |
Usage Guidelines
A specified VLAN MUST be assigned to the peer-link interface, the MLAG peer VLAN, which is dedicated to transmitting MLAG control plane messages but does not allow data messages.
Example
- Configure a peer VLAN for MLAG.
admin@Xorplus# set l3-interface vlan-interface vlan4088 address 10.10.10.24 prefix-length 24 admin@Xorplus# set protocols mlag domain 2 peer-ip 10.10.10.1 peer-link ae2 admin@Xorplus# set interface mlag domain 2 peer-ip 10.10.10.1 peer-vlan 4088
Copyright © 2024 Pica8 Inc. All Rights Reserved.