set protocols pim interface active-active

The set protocols pim interface active-active command is used to turn on PIM active-active configuration. This command will not do anything if you do not have the underlying ability of a MLAG implementation.

The delete protocols pim interface active-active command is used to disable PIM active-active configuration.

Command Syntax

set protocols pim interface <interface-name> active-active

Parameter

Parameter	Description
interface <interface-name>	Specifies an L3 interface. The value could be a VLAN interface name, loopback interface name, routed interface or sub-interface name.The value is a string.

Usage Guidelines

For a multicast sender or receiver to be supported over a dual-attached MLAG bond, you must configure pim active-active.

Example

Set the PIM active-active configuration.

admin@Xorplus# set protocols pim interface vlan-2 active-active
admin@Xorplus# commit