/
set protocols dot1x aaa radius nas-ip

set protocols dot1x aaa radius nas-ip

Owned by Tracy Yang (Unlicensed)
Mar 16, 2021

The set protocols dot1x aaa radius nas-ip command configures the NAS IP address to the interface IP which connected to the RADIUS server.


Command Syntax

set protocols dot1x aaa radius nas-ip <ip-address>


Parameter

Parameter

Description

nas-ip <ip-address>

Specifies the NAS IP address to the interface IP which connected to the RADIUS server.


Usage Guidelines

This command is to set the nas-ip field in RADIUS access-request message. The value of the NAS IP address depends on the port connected to the RADIUS authentication server:

  • If you use the management interface eth0/eth1 to connect to the RADIUS server, the IP address of the management interface eth0/eth1 should be used for the NAS IP address configured here.
  • If you use the L3 VLAN interface to connect to the RADIUS server, the IP address of the L3 VLAN interface should be used for the NAS IP address configured here.


Example

  • Configure the NAS IP address to the interface IP which connected to the RADIUS server.
admin@Xorplus# set protocols dot1x aaa radius nas-ip 10.10.10.100
admin@Xorplus# commit

Copyright © 2025 Pica8 Inc. All Rights Reserved.